Back to Contents Page

Palm Rest

Dell™ Inspiron™ 1300/B120/B130  Service Manual

  Removing the Palm Rest


Removing the Palm Rest

CAUTION: Before performing the following procedures, read the safety instructions in the Product Information Guide.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.
  1. Follow the instructions in Before Working Inside Your Computer.

  2. Remove the hinge cover. See Removing the Hinge Cover.

  3. Remove the optical drive. See Removing the Optical Drive.

  4. Remove the keyboard. See Removing the Keyboard.

  5. Remove the coin-cell battery. See Removing the Coin-Cell Battery.

  6. Remove the display assembly. See Removing the Display Assembly.

  7. Turn the computer upside down and remove the ten M2.5 x 8-mm screws from the bottom of the computer.

  1. Turn the computer top-side up and remove the five M2.5 x 5-mm screws from the top of the palm rest and the remaining two M2.5 x 3-mm screws from near the power button and the activity LEDs.

  1. Disconnect the touch pad connector from the system board by pulling the release tabs forward away from the connector and removing the cable.

1

suspend switch connector

2

touch pad ribbon cable release tabs (2)

3

touch pad ribbon cable

  1. Disconnect the suspend switch connector from the system board.

NOTICE: Carefully separate the palm rest from the base plastics to avoid damage to the palm rest.
  1. Starting at the back center of the palm rest, use your fingers to separate the palm rest from the base plastics by lifting the inside edge of the palm rest.

Back to Contents Page